Special Advertising Section
reply online at www.ecnmag.com/litnews/
JTAG Connector Plugs Directly into PCB!!
No Header! No Brainer!
Our patented range of Plug-of-Nails™ spring-pin cables plug directly
into a tiny footprint of pads and locating holes in your PCB, eliminating
the need for a mating header. Save Cost & Space on Every PCB!
Solutions for: PIC . dsPIC . ARM . MSP430 . Atmel . Generic JTAG . Altera
Xilinx . BDM . C2000 . SPY-BI-WIRE . SPI / IIC . Altium Mini-HDMI . & More
Tag-Connector footprints as small as 0.02 sq. inch (0.13 sq cm)
Mahr Federal has introduced a new addition to their growing family of optical shaft measurement systems.
Competitively priced and designed to provide fast, accurate, fully automatic measurement of smaller shafts and
turned parts directly on the shop floor, the MarShaft™ SCOPE 250 plus features a highly accurate matrix camera with
four million pixels. The system measures parts up to 250 mm in length and 40 mm in diameter with an accuracy that
is previously unknown in this market segment. An MPE (Maximum Permissible Error) of less than 1.5 microns + L/40
when measuring diameter and an even more impressive 3 microns + L/125 when measuring length is significantly
more accurate than other systems using line cameras.
One key to the system’s speed is the state-of-the-art, high-resolution CMOS matrix camera with a live image field of
view of 40 x 24 mm, enabling it to capture an entire part diameter in a single view. With Z-axis positioning speeds of up
to 200 mm/second and an image acquisition rate
of over 120 images per second, measurements are
performed faster than the blink of an eye. Zoom
functions allow measurement of the smallest details
such as chamfers and radii, which can be difficult
and in some cases even impossible to test, with
conventional measuring methods.
For more information, visit www.mahr.com.
Optical shaft measurement systems designed to provide fully
automatic measurement of smaller shafts